Sale

No Wrench Anchor

  • $180.00

Description

Chance® No-Wrench Screw Anchors may be installed by hand or machine. The Thimbleye® Eye or Tripleye®Eye on the rod has a large opening to admit a turning bar for screwing the anchor down. The eye will also fit into an adapter available from most hole-boring machine manufacturers so the anchor may be power-installed. The No-Wrench Screw Anchor consists of a drop-forged steel Thimbleye Eye or Tripleye Eye rod welded to a steel helix. The entire anchor is hot-dip galvanized for long resistance to rust.

    NOTE: If hand installed, holding capacity may be reduced by as much as 10% to 20%. Capacity ratings apply to properly installed      anchors only. Failure to install within 5° of alignment with the guy load will significantly lower strength.

Description

  • Hot dipped galvanized per ASTM A153
  • Number of Helices: 1
  • Eyenut Style: Tripleye
  • No-Wrench Screw Anchors can be installed to a greater depth to reach a firmer soil by using an extension rod.

Sizes

  • 8" X 66" Tripleye
    • Torque rating: 1000 ft-lbs
    • Anchor Helix Diameter: 8in
    • Length: 66 in
    • Rod Diameter: 1in
    • Weight: 21.1lbs
    • Recommended for use on low ropes courses
  • 10" X 66" Tripleye
    • Torque Rating: 2300 ft-lbs
    • Anchor Helix Diameter: 10in
    • Length: 66 in
    • Rod Diameter:1.25in
    • Weight: 30.5lbs
    • Recommended for use on low ropes courses (Standard)
  • 10" X 96" Tripleye
    • Torque Rating: 2300 ft-lbs
    • Anchor Helix Diameter: 10in
    • Length: 96 in
    • Rod Diameter:1.25in
    • Weight: 42.2lbs
    • Recommended for use on high ropes courses (Standard)
  • 14" X 96" Tripleye
    • Torque Rating: 2300 ft-lbs
    • Anchor Helix Diameter: 14in
    • Length: 96 in
    • Rod Diameter:1.25in
    • Weight: 55lbs
    • Recommended for use on high ropes courses